First, the threshold
The threshold is a level that prevents water from escaping from the bathroom. Its design and construction points are:
1. The upper surface of the sill should be inclined to the inside of the bathroom so that the water drops can smoothly slide to the inside of the bathroom;
2. The threshold should be the same width as the door frame, and the door frame should be the same thickness as the wall, so that there will be no big exit when the floor tiles are displayed, and the chance of creating a break will be relatively reduced.
Second, the ground waterproof
There are many kinds of waterproof materials, and water repellents are more commonly used at present. When the waterproof layer is displayed, it should be about 20 cm above the wall, at least not below the height of the threshold. When the floor has a reserved pipe, the waterproof layer also needs to enclose the reserved pipe. After the floor is waterproof and dry, it must be immediately grounded with cement mortar or protective measures to prevent damage to the waterproof layer.
Third, floor tile construction
There are three main points in the construction of floor tiles:
1. There should be about one percent of the slope of the discharge, and the slope faces the floor drain;
2. The joints of the floor tiles shall be the same thickness and shall be aligned with the seams of the wall tiles;
3. When the front wall of the bathtub is tiled, the floor tiles should be attached to the bottom of the wall first, then the bricks should be attached to avoid the breakage.
Fourth, wash the face
Washing the countertop should choose "all-body" (that is, the surface material of the countertop and the inner material composition and brilliance). Do not select a countertop with only one surface of the plastic shell, because the countertop with only the surface rubber shell can not be repaired once it is damaged. (To check whether the table top is "all-body", you can use the light to illuminate from the back side, and the light-transmitting is the "full body" table). In addition, the joint between the countertop and the washbasin must be filled with a grout to prevent water from seeping from the seam.
Five, toilet
Generally, when installing a toilet, it is customary to use cement mortar to fill the toilet. This method is wrong. After fixing the toilet in this way, the toilet cannot be disassembled again. If the pipeline is severely blocked, only knock it off. A way to toilet.
High Wattage Lamp Emergency Conversion Kit
Replacing Emergency Lights,Best Emergency Light,Automatic Emergency Light,Lamp Emergency Conversion Kit,led battery driver
Foshan Nai An Lighting Electric Co.,ltd , https://www.emballast.com