The ceiling is not only beautiful, but also has functions of heat preservation, heat insulation, sound absorption, etc. There are many types of ceilings, one of which is called integrated ceiling. What is an integrated ceiling? The integrated ceiling is in fact the ceiling module and electrical modules such as lighting, ventilation, and heating are all made into standard modular modules that can be integrated together according to actual needs and locations during installation. The integrated ceiling is gradually favored by people because of its own advantages. Here's to introduce the decoration method of integrated ceiling and precautions.
First, before installing the integrated ceiling, you need to be ready to install the various tools and all the raw materials needed.
Second, determine the ceiling treatment method, ceiling installation height, the location of the ventilation fan, the position of the electric wire line, and check whether there is water leakage in the water pipe channel. After everything is ready, the installer will choose to install the boom and keel according to the design drawings previously determined by the owner in the store, as well as the size of the kitchen space. The two must be coordinated with each other. The level between the keel and the keel must be the same. The adjustment of the rod and the edge angle must be consistent.
After determining the installation height, install the ceiling line and then install the expansion pipe to determine the force point. The keel is the basis for the buckle plate and electrical installation. Therefore, the keel must be flat and the spacing deviation should be controlled within the allowable range. If the dimensions are deviated, the adjustment should be made in the order of insertion, and no hard insertion is required to prevent deformation. .
Then, after the keel has been set up and the electrical installation port is reserved, the buckle board can be installed. When installing the gussets, pay attention to the spacing of gussets to be 0, the four corners of the gussets should be in a shape of “10â€, and the height of the gussets should be consistent to achieve a compact and seamless effect. If the electrical module is heavy, it needs a screw to fix it. If you choose an integrated bath heater that integrates lighting, heating, ventilation, and other functions, it is much easier to install.
After the installation of the integrated ceiling is completed, in order to ensure the safety and functionality during the future use, the owner needs to inspect whether the construction is qualified or not. The following detailed acceptance steps are provided:
First, check whether the visual installation of the corner lines is good or not. To make the 90-degree angle seamless, there is no obvious distortion. Observe the overall flatness of the gussets and the gaps between the gussets and visually see if they are good.
Second, check the strength of the screw. Remove a few gussets and check that the distance between the shank rods meets the installation standards. Then pull a few screws with your hand to determine if there is looseness.
Third, check the number of electrical installations. Try to push the electrical body with your hand to see if the appliance will fall off the triangle keel.
Fourth, test whether the normal function of electrical appliances. You can turn on the switch and observe whether the electrical appliance is working properly. If it is warm, after 15 seconds of driving, you feel a sense of heat. It means no problem. The position of the ventilation and heating module is reasonable. When it is turned on, whether the sound is normal or not, there must be no obvious noise. After the warm air is turned on, it is necessary to feel hot air at the center of 1.8-2 meters away from the wind, which proves that the warm air is normal.
Integrated ceiling kitchen integrated ceiling
Digital Tape Measure,Laser Measure Tapes,Laser Digital Measure Tape,Digital Display Laser Measure Tapes
Shangqiu Hengli Measuring Tools Co.,Ltd , https://www.henglimtools.com