KCB gear pump features: KCB gear pump mainly gear, shaft, pump, safety valve, shaft seal (special requirements can be used magnetic drive, zero leakage structure) formed. The gears are heat-treated to a higher hardness and strength and mounted with the shaft in a replaceable hub. The lubrication of all parts in the pump is automatically achieved using the output medium while the pump is in operation. KCB gear pump has a well-designed oil drain and oil return groove, the gear in the work to withstand the torque of the smallest, so the bearing load, wear a small, high pump efficiency. The pump has a safety valve as overload protection, safety valve full back pressure of 1.5 times the rated pump exclusion pressure, but also allows the discharge pressure within the scope of the actual need to be adjusted. But note that the safety valve can not be used for long-term work of the valve, if necessary, can be installed separately in the pipeline. From the spindle extension to the pump to see, clockwise rotation. Whether the pump is fastened by fasteners; whether the valve in and out of the pipe is opened; whether the direction of rotation of the pump meets the requirements; and when the high temperature medium is started, the jog operation should be used for one minute before connecting the work. KCB gear pump maintenance work: pay attention to KCB gear pump pressure should be consistent with the technical specifications; Note shaft seal, if leakage occurs, depending on the degree of fine-tuning the screw, do not over-tighten; Do not adjust the safety valve Adjust the bolt rod; produce abnormal noise, should immediately stop working for inspection.
Stop Valves are closed by screwing a rubber gasket down onto a seat in the middle of the valve. Pros only use small versions that act as shutoff valves for fixtures such as sinks and toilets and outdoor sillcocks. Flow is inefficient because of the circuitous route the fluid (water, in most cases) has to follow. It's important to orient the valve in the right direction with the arrow (cast into the side of the valve) aligned with flow direction. That way, water flows against the bottom of the rubber gasket. If the valve is put in backward, the flow will force the gasket away from the top of the valve.
Stop Valves, Shower Stop Valve, Water Stop Valves, Brass Stop Valve
ZHEJIANG KINGSIR VALVE CO., LTD. , https://www.kingsir-valve.com