Floor: 1, polished floor to be smooth, can not appear pits and scratches, the corner to be polished with a grinding machine; 2, the floor at least to use the floor wax oil three times; 3, laying the left side of the four millimeters reserved space, and then with the skirting line Edge cover; 4, wood floors should use plywood as the bottom, the bottom of the board should be placed with oil-proof paper or plastic film, and the four sides to reserve vacancies.
Tile: 1, brick surface should be flat, the angle should be accurate, the interface to the line; 2, before the use of tiles in the water for half a day; 3, the toilet floor should have a suitable slope, not water; 4, after the tile interface to white cement Wipe the white cement with rattan silk, do not leave cement stains on the surface of the brick; 5. After the tiles are covered, use cardboard to cover the brick surface, and walk on the brick surface after at least 1 hour.
Wallpaper: 1. Brush the waterproof oil behind the wall first and then polish it. Grind it with sandpaper every time. There must be a gap repair immediately. The concave wall of the convex wall cannot be seen with the naked eye. 2, the wallpaper to meet the mouth to accurately paste clothes, no blistering, according to the provisions of the flowers, with a sharp incision, there must be no paper edge tearing phenomenon.
Paint: 1, the surface color is correct, uniform, smooth and smooth, no teardrops, too thick, through the bottom, blistering, etc.; 2, the paint border straight and tidy, not out of bounds; 3, the wall of the gray does not see convex concave Bit, flat corner. Board and board, board and wall interface, should be attached to the tape after the ash; 4, latex paint in the distance from the point of view, should not see the scan marks; 5, nails to be accurate and smooth coloring; 6, try not to be wet Weather brush paint.
In addition, the wooden board surface should be smooth and smooth, without planing marks, squeaks and burrs, the pattern is clear, the paint surface color is uniform, the gap is tight, the joints are staggered, the surface is clean, and the joints are straight and straight. In terms of bonding, it should be firmly bonded, the surface should be clean, there should be no overflowing glue, and the floorboards should be arranged reasonably and beautifully. The joints are tight, the surface is smooth, the seams are arranged in a reasonable and beautiful manner, the mouth is straight, and the cutting angle is accurate. Hard wood floor wax, soft wax, wax spray have to be uniform without bottom, smooth and bright, uniform color
DELL floor nature floor paint cement latex paint floor tile tile floor tile kitchen tile
Tempered Glass is often used in applications where using standard glass could pose a potential danger. Tempered glass is stronger than standard glass and does not shatter into large shards when broken. This is important, because it can greatly minimize potential danger in the case of a break. Manufactured through a process of extreme heating and rapid cooling, tempered glass is much harder than normal glass.
Tempered or toughened glass is a type of safety glass processed by controlled thermal to increase its strength compared with normal glass. Tempering puts the outer surfaces into compression and the interior into tension. Such stresses cause the glass, when broken, to crumble into small granular chunks instead of splintering into jagged shards as plate glass (a.k.a. annealed glass) does. The granular chunks are less likely to cause injury.
Clear tempered glass is most widely used windows, doors, partitions, shower room, table top, glass wall and so on. It is substrate, it can be processed into printed tempered glass, back painted tempered glass, frosted tempered glass and so on.
fully tempered glass,tempered glass top,round tempered glass,cost of tempered glass per square foot,low iron tempered glass
Shanghai Lead Glass Co.,Ltd , https://www.leadglazing.com